Icom IC-V8 Service Manual page 4

SECTION 1
' ' GENERAL
• Frequency coverage
• Type of emission
• Frequency stability
(–10˚C to +60˚C; +14˚F to +140˚F)
• Tuning steps
• Antnna connector
• Power supply requirement
(negative ground)
• Number of memory channel
• Call channel
• Scanning mode
• Current drain (approx.)
• Usable temperature range
• Dimensions (projections not included)
• Weight (with ant., BP-222)
' ' TRANSMITTER
• RF output power (at 7.2 V DC)
(with supplied battery pack)
• Modulation system
• Maximum frequency deviation
• Spurious emissions
• Ext. microphone connector
' ' RECEIVER
• Receive system
• Intermediate frequencies
• Sensitivity
• Squelch sensitivity
• Adjacent channel selectivity
• Spurious response rejection
• Intermodulation rejection ratio
• Audio output power (at 7.2 V DC)
• Ext. speaker connector
All stated specifications are subject to change without notice or obligation.
SPECIFICATIONS
:
Version
[USA]
[GEN]
*Specifications Guaranteed: 144–148 MHz only
: F2D/ F3E
: ± 10 ppm
: 5, 10, 12.5, 15, 20, 25, 30 or 50 kHz
: BNC (50
: 7.2 V DC (Operable voltage range: 6.0 to 10.3 V)
: 100 channels
: 1 channel
: Program, Memory, Skip, Priority or Tone
: Transmit
Receive
: –10˚C to +60˚C; +14˚F to +140˚F
: 54(W) 132(H)
: 350 g; 12.3 oz.
: 5.5 W / 0.5 W (High / Low)
: Variable reactance frequency modulation
: ±5.0 kHz
: Less than –60 dB
: 3-conductor 2.5(d) mm (
: Double conversion superheterodyne system
: 1st
2nd
: 0.16 µV at 12 dB SINAD (typical)
: 0.1 µV at threshold (typical)
: 65 dB (typical)
: 75 dB (typical)
: 65 dB (typical)
: More than 300 mW at 10% distortion with an 8
: 3-conductor 3.5(d) mm (
Receive
136.000–174.000 MHz*
)
at High (5.5 W) 2.0 A
at Low (0.5 W) 0.7 A
Max. audio 250 mA
stand-by 70 mA
power saved 20 mA
35(D) mm; 2 1 ⁄ (W)
8
1 ⁄ ")/2.2 k
10
21.7 MHz
450 kHz
1 ⁄ ")/8
8
1 - 1
Transmit
144.000–148.000 MHz
136.000–174.000 MHz*
5 3 ⁄ (H) 1 3 ⁄ (D) in.
16 8
load