Table of Contents
Advertisement
WARNING
Turn controls and gas source or tank OFF when not
in use.
CAUTION
If ignition does NOT occur in 5 seconds, turn the
burner controls OFF, wait 5 minutes and repeat the
lighting procedure. If the burner does not ignite with
the valve open, gas will continue to flow out of the
burner and could accidently ignite with risk of injury.
Griddle Burner Match-Lighting
▲
Do not lean over grill while lighting.
1.Turn burner control valve to the
2.Open lid and leave open. Turn ON gas at LP cylinder.
3.Place match into match holder (inside door.)
Light match, place into match lighting opening.
4.Push in and burner knob to
burner lights and stays lit. Verify burner flame through
match light opening.
5.If ignition does NOT occur in 5 seconds, turn the burner
control knob to
(OFF) position, wait 5 minutes, and
repeat the match lighting procedure.
Match Light Opening
Stove Top burner Ignitor Lighting
▲
Do not lean over grill while lighting.
1. Turn all burner control valve to the
2. Open lid and leave open. Turn ON gas at LP cylinder.
3. Turn burner knob to the
the ELECTRONIC IGNITOR button.
4. Once burner has ignited, turn knob to desired setting.
5. If burner does not light, turn knob to the
wait 5 minutes, then repeat lighting procedure.
WARNING: Top cover must be open when burner
is in operation.
8
(OFF) position.
position. Be sure
(OFF) position
(HIGH) position, push and hold
(OFF) position,
Stove Top burner Match Lighting
1. Turn all burner control valves to the
2. Open lid and leave open. Turn ON gas at LP cylinder.
3. Place match into match holder (inside door.)
Light match, place match near burner.
4.Turn burner knob to the
Be sure burner lights and stays lit.
5. If burner does not light, turn knob to the
wait 5 minutes, then repeat lighting procedure.
Burner Flame Check
• Remove cooking grates and troughs. Light burners, rotate
knobs from the HI position to the LOW position. You should
see a smaller flame in the LOW position than seen on the
HI position. Perform burner flame check
on sideburner, also. Always check flame prior to each use. If
only low flame is seen refer to "Sudden drop or low flame" in
the Troubleshooting Section.
Turning Griddle / Stove Top Off
• Turn all knobs to the OFF position. Turn LP cylinder off by
turning hand-wheel clockwise to a full stop.
Ignitor Check
• Turn gas OFF at LP cylinder. Press and hold electronic ignitor
button. "Click" should be heard and spark seen each time
between each collector box or burner and electrode. See
"Troubleshooting" if no click or spark.
Valve Check
• Important: Make sure gas is OFF at LP cylinder before
checking valves. Knobs lock in
valves, first push in knobs and release, knobs should spring
back. If knobs do not spring back, replace valve assembly
before using grill. Turn knobs to LOW position then turn back to
OFF
position. Valves should turn smoothly.
Hose Check
• Before each use, check to see if hoses are cut or worn.
Replace damaged hoses before using stove top. Use only
valve/hose/regulator specified by manufacturer.
(OFF) position.
(HIGH) position,
(OFF) position,
HI position
LOW position
OFF
position. To check
Advertisement
Table of Contents
Troubleshooting
