Char-Broil 463240613 Product Manual page 10

Cleaning the Burner Assembly
Follow these instructions to clean and/or replace parts of burner
assembly or if you have trouble igniting stove top.
1. Turn gas OFF at control knobs and LP cylinder.
Remove screws that hold orifice holder with the burner
2.
venturi. Figure A
Remove cooking grate.
3.
4. Remove wing nuts from inside cart to disengage it.
Figure B
Carefully lift up the burner enough to expose the electrode
5.
wire. Detach wire from electrode underneath the burner
Carefully take out the burner to clean. Figure C
6.
While cleaning, make sure that the ignitor wire is not bent
7.
or broken.
A
Burner Venturi
View from under firebox
B
Remove three Wing Nuts
from inside cart
C
10
NOTE:
Remove
Screws
We suggest three ways to clean the burner tubes. Use the one
easiest for you.
(A) Bend a stiff wire (a light weight coat hanger works well)
into a small hook. Run the hook through each burner
venturi tube several times.
(B) Use a narrow bottle brush with a flexible handle (do not
use a brass wire brush), run the brush through each
burner venturi tube several times.
(C) Wear eye protection: Use an air hose to force air into
the burner tube and out the burner ports. Check each
port to make sure air comes out each hole.
Wire brush entire outer surface of burner to remove food
8.
residue and dirt.
Clean any blocked ports with a stiff wire such as an open
9.
paper clip.
Check burner for damage, due to normal wear and corrosion
10.
some holes may become enlarged. If any large cracks or
holes are found replace burner.
VERY IMPORTANT: Burner venturi must be attached with orifice
holder properly. see illustration below.
After cleaning put the burner back into the firebox and attach
12.
the electrode wire onto the electrode connector under the
burner.
13.
Place burner into position and reinstall the wing nuts.
Under the firebox, attach the orifice holder with the venturi tube.
14.
with the screws previous removed.
15. Replace the cooking grate.
Correct
engagement
NOTE:
Reinstall
Screws