Table of Contents
Advertisement
5
Connect the wire from burner electrode into the back of Electronic ignition module, positions 1. Connect the two wires [(a) and
(b)] from switch wiring harness into the back of Electronic ignition module.
NOTE: Switch terminals are larger than electrode terminal and should only be installed in location shown as (a),(b).
Release cap and nut from electronic ignition module. Attach Electronic ignition module to front brace with the nut. Insert AAA
battery into module, negati v e
(-)
end first. Replace the cap.
Back of electronic ignition module
AAA battery
Front brace
Nut
(-)
(+)
1
(a) (b)
Cap
Electronic ignition module
On back of the stove top, attach back panel to cart side panels using four #8x3/8" self-tapping screws.
6
#8x3/8"self-tapping
screw
Back panel
17
Advertisement
Table of Contents
Troubleshooting
