Download  Print this page

Hardware Requirements - Cisco 7916 User Manual

Unified ip phone expansion module
Hide thumbs
   

Advertisement

The Cisco Unified IP Phone Expansion Module 7916 allows for 48 additional buttons (with two modules), but the
number of buttons depends on the Cisco Unified Communications Manager and Cisco Unified Communications
Manager Express Release, as listed in Table's 5 and 6.
Table 5.
Call-Control Release
Cisco Unified Communications Manager 4.2(3)SR3a, 4.3(2), 5.1(3)b, and 6.1(1)
Cisco Unified Communications Manager 7.1(3) / Cisco IP Phone Firmware 8.5(3)
and later
Cisco Unified Communications Manager Express 4.3/7.0 and later
Table 6.
Call-Control Release
Cisco Unified Communications Manager 7.0 and 7.1
Cisco Unified Communications Manager 7.1(3) / Cisco IP Phone Firmware 8.5(3)
and later
Cisco Unified Communications Manager Express 4.3/7.0 and later

Hardware Requirements

Cisco Unified IP Phone 7962G, 7965G, and 7975G models
Cisco Unified IP Phone Expansion Module 7916 (CP-7916=)
Footstand is required; single (CP-SINGLFOOTSTAND=) or double (CP-DOUBLFOOTSTAND=) (required
items for double Cisco Unified Expansion Module installation shown in Figure 4).
Power cube (CP-PWR-CUBE-3=) and cord (CP-PWR-CORD-xx=) to supply local power
Table 6 gives power options for the Cisco Unified IP Phone Expansion Module 7916.
© 2009 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Cisco Unified IP Phone Expansion Module 7916 Button Support (SCCP)
Cisco Unified IP Phone Expansion Module 7916 Button Support (SIP)
The maximum is two modules (connecting cable supplied with each Cisco Unified IP Phone Expansion
Module 7916)
Replacement of the standard Cisco Unified IP phone footstand is required. The standard footstand is
replaced with a two-piece footstand specifically designed to support the Cisco Unified IP Phone Expansion
Module 7916. Two footstands are available: a single footstand when one Cisco Unified IP Phone
Expansion Module 7916 is used and a double footstand when two Cisco Unified IP Phone Expansion
Module 7916 modules are used.
The only tool required for installation of the Cisco Unified IP Phone Expansion Module 7916 is a flat-blade
screwdriver or other appropriate tool to unlatch the pins securing the footstand to the Cisco Unified IP
Phone 7962G, 7965G, and 7975G models.
Total Number of Buttons Supported
Cisco Unified IP Phone
Cisco Unified IP Phone
7962G and 7965G Models
7975G
42
42
54
56
54
56
Total Number of Buttons Supported
Cisco Unified IP Phone
Cisco Unified IP Phone
7962G and 7965G Models
7975G
36
36
54
56
54
56
Data Sheet
Page 4 of 7

Advertisement

Table of Contents
loading

  Also See for Cisco 7916

  Related Manuals for Cisco 7916

This manual is also suitable for:

Cp-7916