Husqvarna 42 Workshop Manual page 49

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Changing a Bar Stud
Empty and rinse out the oil tank. Using a drift
punch, tap the bar stud into the oil tank. Extract
the stud through the oil filler opening. Insert a
smaller diameter wire through the bar stud hole
in the crankcase and out the oil filler opening.
Wrap the end of the wire around the bar stud
threads, then guide the stud through the oil
tank and stud hole. Remove the wire. Place a
sleeve or washers over the stud. Thread a stud
nut down onto the stud to pull the stud into its
seat.
Changing the Crankshaft Seals
The crankshaft seals are accessible after
removing:
The flywheel and, if equipped, the heated
handle generator as instructed in Section 6.
Ignition Systems and the oil pump as
instructed in Section 5.
Chain Lubrication Systems in Section 8.
The seals can be pried out using a suitable
screwdriver. Be careful not to scratch or dam-
age the crankshaft during seal removal.
www.mymowerparts.com
Cylinder and Piston
1 1
47