Husqvarna 42 Workshop Manual page 33

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
Assembly
.
Lubricate pump parts with chain oil. Push
pump piston to bottom of housing. Install and
seat adjusting screw (1). Back adjustment
screw out 1-1/2 turns for initial adjustment.
Make sure locking tabs fit in groove of adjusting
screw. Tighten lock screw (2). Press in sealing
plug (3) and install rubber output sleeve (4).
Thread worm gear into puller sleeve until flush
with end of sleeve. Place sleeve with gear over
the end of the crankshaft. Tap sleeve down with
a plastic hammer until gear contacts the shoul-
der on the crankshaft.
Place suction hose with filter in oil tank
opening.
Chain Lubrication System
www.mymowerparts.com
8
I