Husqvarna 42 Workshop Manual page 54

For Husqvarna Parts Call 606-678-9623 or 606-561-4983
12
Crankcase and Crankshaft
52
Position the crankcase gasket onto the ignition
side crankcase half using a light coating of
grease to hold it in place.
NOTE: The crankcase alignment pins should
be located in the ignition side crankcase half.
Slide the drive side crankcase half (right) onto
the crankshaft, then mount the assembly tool.
Pull the crankshaft into the crankcase half
while guiding the two halves together. If neces-
sary, start a few crankcase screws to hold the
gasket in place. Make sure the crankshaft is
flush against the bearing, then remove the
assembly tool.
Install ail the crankcase screws except the top
front screw which also retains the bar spike
and muffler support. Starting with the screws
around the crankshaft, tighten all six screws to
7-9 Nm (5.1 -6.6 ft. Ibs.) torque.
www.mymowerparts.com