Toa SR-D8- M Installation Manual page 28

Step 4. Remove screws from speaker sides.
Step 5. Attach each speaker bracket to the speaker.
Bracket
Hoisting Bracket On top of the speaker stack Mount an eyebolt.
Speaker Bracket Center of each speaker
Extension Plate Joint part of speakers
Step 6. Loosely tighten bolts in the mounting holes located on both sides of the lower part of each speaker
bracket.
28
Mounting position
Eyebolt of the SR-D8HB
Hoisting bracket of theSR-D8HB
5
Hex bolt M6×20 (with spring
and plain washers)*
SR-D8-M
4
Speaker bracket
of the SR-D8WB
L bracket of
the SR-D8EP
5
4
Remove screws.
Note
Only 8 screws out of all removed
in this step are used in Step 10.
No other screws are used.
SR-D8-S
Use only for hoisting the speaker stack at speaker
installation.
Securely tighten 6 angle adjustment bolts (4 on the
upper side and 2 on the lower side) of each speaker
bracket, then attach each bracket to the speaker.
1
Securely tighten.
A
6
Loosely tighten
5
bolts.
Hex bolt M10×30
(with spring and
plain washers)*
3
Hex bolt M6×20 (with spring
and plain washers)*
2
5
R bracket of the SR-D8EP
Securely tighten.
Speaker bracket
of the SR-D8WB
Hex bolt M10×30 (with spring
and plain washers)*
6
Hex bolt M6×20 (with spring
and plain washers)*
3
Remark
A
3
Supplied with the SR-D8RB
*
1
Supplied with the SR-D8EP
*
2
Supplied with the SR-D8WB
*
3