Toa SR-D8- M Installation Manual page 27

11.2.2. Wall mounting
Below is the procedure for installation in 2-unit configuration.
Step 1. Install anchor stud bolts in the wall (see the figure in the lower right).
Note: For mounting dimensions in 3-unit and 4-unit configurations, see p. 30.
Step 2. Assemble the bracket sets to be mounted to the wall.
Step 3. Mount the assembled bracket sets to the wall.
Wall bracket of
the SR-D8WB
2
Hex bolt M8×25
(with spring and plain
washers, supplied
with the SR-D8CL)
2
Hex bolt M8×25
(with spring and plain
washers,supplied
with the SR-D8CL)
Bracket Mounting Anchor Stud Bolts (M10)
To determine stud bolt projection from the wall
surface, refer to the dimensions indicated below:
[Single nut]
18 – 30
(0.71 – 1.18)
Wall
Unit: mm (in)
Anchor Stud Bolt M10
(Prepare separately.)
Nut for M10
(Prepare separately.)
3
SR-D8CL
Wall bracket of
the SR-D8WB
[Anchor Stud Bolt Mounting Dimensions
(2-Unit Configuration)]
[Double nut]
25 – 30
(0.98 – 1.18)
Wall
Wall
Unit: mm (in)
56 (2.2)
120.4
(4.74)
9-12×28
(9-0.47×1.1)
Note
Gray area indicates speaker
mounting position.
27