Toa SR-D8- M Installation Manual page 25

Step 4. Remove screws from speaker sides.
Step 5. Securely tighten 6 angle adjustment bolts (4
on the upper side and 2 on the lower side)
of each speaker bracket, then attach each
bracket to the speaker.
Step 6. Loosely tighten bolts in the mounting holes
located on both sides of the lower part of
each speaker bracket.
Step 7. Hang the loosely tightened bolts on the wall
bracket.
[completed Mounting]
[completed
Dimensional Diagram]
Unit: mm (in)
373 (14.69)
118 (4.65)
SR-D8-M
[Enlarged figure of Part A]
7
Hang on wall bracket.
Speaker bracket
of the SR-D8WB
Note
Left and right angles can be adjusted within a range of 0° – 90°.
If no angle adjustments are required, this completes the installation. When
performing angle adjustments, please refer to "Angle Adjustment" on p. 31.
Step 8. Install bolts in left- and right-side mounting
holes located in the upper part of the speaker
bracket.
Step 9. Securely tighten all bolts.
Wall bracket of
the SR-D8WB
Securely tighten.
6
5
Loosely tighten
bolts.
Speaker bracket
of the SR-D8WB
5
4
Hex bolt M6×20 (with spring
and plain washers)*
Remove screws.
Note
The removed screws are not used.
Wall bracket of
Unit: mm (in)
the SR-D8WB
A
Securely tighten.
6
Hex bolt M10×30 (with spring
and plain washers)*
* Supplied with the SR-D8WB
Hex bolt M10×30
(with spring and
plain washers)*
8
7
Wall
A
25