Installation; Installing A Single Sr-D8-M Unit - Toa SR-D8- M Installation Manual

Active line array speaker systems
Table of Contents

Advertisement

11. INSTALLATION

11.1. Installing a Single Sr-D8-M Unit

WArNINg
• Attach the safety wire, strong enough to withstand heavy load, to the unit.
• The apparatus shall be connected to a mains socket outlet with a protective earthing connection.
• The socket-outlet shall be installed near the equipment and the plug (disconnecting device) shall be
easily accessible.
• Do not use this speaker in a flying installation.
• Only install speaker units in locations that can structurally support the weight of the speaker and its
mounting brackets (Total weight: 31 kg or 68.34 lb).
• Nuts and bolts used for wall mounting are not supplied with the unit.
Use hardware appropriate to the wall's structure and composition.
• Never install the unit on the wall tilting over 30°.
• Never adjust the speaker angle to the left or right when the unit is installed facing up or down.
11.1.1. required mounting brackets
Mounting Bracket
SR-D8WB Wall Mounting Bracket
SR-D8CS Wall Mounting Adapter
SR-D8FB Fixing Bar
11.1.2. Wall mounting
Step 1. Install anchor stud
bolts in the wall (see
the figure at right).
Step 2. Assemble the bracket sets to be mounted to the wall.
Step 3. Mount the assembled bracket sets to the wall.
Wall bracket of
the SR-D8WB
2
Hex bolt M8×25
(with spring and plain
washers, supplied
with the SR-D8CS)
24
Number
2
Arrange 9 sets of M10 anchor bolts and M10 nuts separately.
1
2
Use when setting left or right angles to over 45°.
Bracket Mounting Anchor Stud Bolts (M10)
To determine stud bolt projection from the wall
surface, refer to the dimensions indicated below:
[Single nut]
18 – 30
(0.71 – 1.18)
Unit: mm (in)
Anchor Stud Bolt M10
(Prepare separately.)
Nut for M10
(Prepare separately.)
3
SR-D8CS
Hex bolt M8×25
(with spring and plain
2
washers, supplied
with the SR-D8CS)
Wall bracket of
the SR-D8WB
Remark
[Double nut]
25 – 30
(0.98 – 1.18)
Wall
Wall
Wall
[Anchor Stud Bolt
Mounting Dimensions]
Unit: mm (in)
56 (2.2)
120.4
9-12×28
(4.74)
(9-0.47×1.1)
Note
Gray area indicates speaker
mounting position.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sr-d8-s

Table of Contents