Canon PIXMA MP500 Service Manual page 37

7 times Orange (Alarm) China
8 times Green (COPY)
9 times or
Orange (Alarm) Return to the menu selection
more
Note: After setting the destination, be sure to initialize the EEPROM. The destination setting may not
be valid unless the EEPROM is initialized after destination settings.
Confirm the model name and destination in service test print or EEPROM information print.
[See 3.4. Verification Items, (1) Service test print, or (2) EEPROM information print.]
<Waste ink amount setting procedures>
Set the waste ink amount data to a replaced new EEPROM after the logic board is replaced in servicing.
1) Before replacement of the logic board ass'y, check the waste ink amount (0% to 100%) in EEPROM
information print. [See 3.4. Verification Items, (2) EEPROM information print.]
2) In the waste ink amount setting mode, press the Stop/Reset button the specified number of time(s) according to
the waste ink absorber whose value should be transferred to the replaced new EEPROM. (Only the main waste
ink absorber for the MP500)
Time(s)
0 times Main waste ink absorber
1 time
Platen waste ink absorber
Both the main and platen waste ink
2 times
absorbers
3 times or
Not valid
more
3) Press the ON/OFF button to proceed to the next step.
4) The waste ink amount can be set in 10% increments by pressing the Stop/Reset button. Press the Stop/Reset
button the appropriate number of time(s) to select the value which is closest to the actual waste ink amount.
Time(s)
0 times
1 time
2 times
3 times
4 times
5 times
6 times
7 times
8 times
9 times
10 times or more
Asia
Taiwan
Waste ink absorber
Waste ink amount value to be set (%)
0%
10%
20%
30%
40%
50%
60%
70%
80%
90%
Not valid.
Press the ON/OFF button to return to the waste ink amount setting mode.
Not valid for the MP500
Only the main waste ink absorber is valid for the
MP500
Press the ON/OFF button to return to the waste ink
amount setting mode.
1-31
Supported
Supported
Supported
Remarks