Canon PIXMA MP500 Service Manual page 12

[1660]
The print head is not
installed [1401], or it is
not properly installed
(print head temperature
sensor error [1403] /
faulty EEPROM data of
the print head [1405]
Inner cover open.
*2
[1841]
Inner cover open during
printing on paper.
*2
[1846]
Inner cover open during
printing on paper (print
*1
continuable). [1851]
Inner cover open during
printing on paper (print
NOT continuable).
*1
[1856]
Inner cover closed
during CD / DVD
printing (print
*1
continuable). [1850]
Inner cover closed
during CD / DVD
printing (print NOT
*1
continuable). [1855]
Multiple ink tanks of
the same color installed.
[1681]
Ink tank in a wrong
position. [1680]
Warning: The waste
ink absorber becomes
almost full. [1700]
The connected digital
camera or digital video
camera does not
support Camera Direct
Printing. [2001]
Automatic duplex
printing cannot be
performed. [1310]
Print head is not installed. Install
the print head.
The type of print head is
incorrect. Install the correct print
head.
Inner cover is open. Close the
inner cover and press [OK].
Open the inner cover, place the
CD-R tray and press [OK].
(Applicable ink tank icon)
More than one ink tank of the
following color is installed.
Some ink cartridges are not
installed in place.
The waste ink absorber is almost
full. Press [OK] to continue but
early replacement recommended.
<See manual>
Incompatible device detected.
Remove the device.
This paper is not compatible with
duplex printing. Remove the
paper and press [OK].
properly, and confirm that the
LED's of all the ink tanks light
red.
Install the print head properly.
Close the inner cover, and press
the OK button.
Close the inner cover, and press
the OK button.
Close the inner cover, and press
the OK button.
Close the inner cover, and press
the OK button to clear the error.
The paper being printed at error
occurrence will be ejected
without printing the remaining
data for the ejected paper, then
printing will resume from the
next page.
Open the inner cover which
functions as the CD / DVD tray
feeder, set the CD / DVD tray in
the feeder, and press the OK
button.
Open the inner cover, and press
the OK button to clear the error.
The CD or DVD being printed at
error occurrence will be ejected
without printing the remaining
data for the ejected CD or DVD,
then the next print job will be
done.
Replace the wrong ink tank(s)
with the correct one(s).
Install the ink tank(s) in the
correct position.
Press the OK button.
Remove the cable between the
camera and the machine.
Press the OK button to eject the
paper being used at error
occurrence. Printing will resume
from on the front side of the next
page.
1-6
The service call error,
indicating the waste ink
absorber is full, is likely
to occur soon.
Data which was to be
printed on the back side
of paper at error
occurrence is skipped
(not printed).