Philips Pronto NG User Manual page 54

FAQ
How do I reset Pronto NG?
Normally, resetting Pronto NG is not necessary. However, if Pronto NG's touch
screen freezes or if you notice unusual behaviour, you need to perform a reset to
get Pronto NG running again.
1 Press the latch on the battery cover with your thumb and then slide the
cover forward firmly.
2 Lift off the battery cover.
You can find the Reset button in the battery compartment.
3 Use an unfolded paperclip or a sharp
pencil to carefully press the Reset
button.
Pronto NG restarts.
Pronto NG beeps twice to indicate
it is ready for use.
4 Set the time again. See 'Changing the Time' on page 12 for more
information.
Note
Why does a device respond to some RF signals and not to others?
Not all commands for all devices work properly with RF signals.
If a device does not respond properly to RF signals sent out by Pronto NG, you
have to reconfigure Pronto NG to operate the device with IR signals.
User Guide
52
If you reset Pronto NG, all personal changes like saved and programmed
commands, IR codes, timers and macros are retained.
Reset button