Table of Contents
Advertisement
4.
Starting
While
still
holding
preheat
switch
depressed,
depress
the
start
switch.
The
starter
motor will run thereby cranking
the
eng ine.
As
soon
as
the
eng ine runs,
release the start
switch which will return to its
normally open
posi tion.
Con-
tinue
holding
the
preheat
switch
depressed
for
2
or
3
seconds.
This defeats the low
oil pressure shutdown until the
engine
oil
pressure
rises
to
normal
running
pressure.
Now
release the preheat switch.
PREHEAT
START
STOP
~
Should the engine not start when start switch is depressed for 10 to
12 seconds, wait 30 seconds and repeat "3" with adequate preheat time.
Never run the starter motor for more than 30 seconds at a time.
5.
Operation
With
the
engine
running,
check
that
oil
pressure
and
battery
charge voltage are registering and that raw water is discharging
with the exhaust.
During engine operation, do not depress start
switch as this will damage starter motor.
6.
Warm-up operation
Operate at reduced load until water temperature rises to the 140
to 150 degree range.
STOPPING PROCEDURE
1.
Stop
To stop the generator,
depress
the
stop
switch
until
engine
stops
completely
and
then
release.
28
PREHEAT
START
STOP
~
J
Advertisement
Table of Contents
