Controls And Features (Input Card: Optional) - JVC TM-H1950CG Instructions Manual

CONTROLS AND FEATURES
(INPUT CARD: OPTIONAL)
COMPONENT/RGB INPUT CARD (OPTIONAL:
IF-C01COMG)
G / Y
IN OUT
B/P /B-Y
B
1
IN OUT
R/P /B-Y
R
IN OUT
HD/C
S
2
IN OUT
VD
IN IN OUT OUT
AUDIO
3
IN OUT
SDI INPUT CARD (OPTIONAL: IF-C01SDG)
SWITCHED
OUT
1
IN
SDI 1
2
IN SDI 2
AUDIO 1
3
IN OUT
AUDIO 2
Note:
● The optional input cards shown below cannot be used.
Using any of these cards will void your warranty and may
result in damage or malfunction.
*Video input card (IF-C01PNG)
*HD-SDI input card (IF-C01HSDG)
*HD-SDI input card (IF-C12HSDG)
Video input/output terminals
1
Input (IN) and output (OUT) terminals for component
(color deference) or RGB signals.
The IN and OUT terminals are bridge-connected.
(When no cable is connected to the OUT terminal, the
input signal is automatically terminated.)
Select component signal : press INPUT SELECT C button
Select RGB signal
Synchronized signal input/output terminals
2
Input (IN) and output (OUT) terminals for the vertical,
4
horizontal or complex synchronized signals.
External sync is available with RGB input only.
The IN and OUT terminals are bridge-connected.
(When no cable is connected to the OUT terminal, the
input signal is automatically terminated.)
G on SYNC cannot be used with RGB input.
Audio input/output terminals
3
Input (IN) and output (OUT) terminals for audio signals.
The IN and OUT terminals are bridge-connected.
Connection terminal (to a Color Video Monitor)
4
Attach to the connection terminal of your color video
monitor.
1 Output terminal for a selected component
serial digital signal
Output terminal for a selected digital signal (the input
displayed on the screen). The output signal is cable-
compensated.
NOTE: When the monitor's main power is OFF, no digital
signal is output.
In the standby mode, the signal from the SDI 1 terminal is
output.
4
2 Input terminals for component serial digital
signals
Input terminals for the digital signal.
Select SDI 1 : press INPUT SELECT C button
Select SDI 2 : press INPUT SELECT D button
3 Audio input/output terminals
Input (IN) and output (OUT) terminals for the analog
signals corresponding to SDI 1 and SDI 2.
NOTE: This input card cannot decode audio data even if
contained in the input digital signal.
Connection terminal (to a Color Video
4
Monitor)
Attach to the connection terminal of your color video
monitor.
: press INPUT SELECT D button
7