Valve Access And Service - Outdoor Lifestyles DAKOTA-AU Installation & Operation Instructions

A. Valve Access and Service
• The gas valve can be accessed behind the cement
refractory panel on the right side of the fireplace.
• Remove door lock screw. Lift doors out and set aside.
There is a washer under each door. Be careful not to lose
the washers.
Figure 10.1 Lift Out Doors
• Remove logs if access is necessary after installation is
complete. See Section 8.C. Remove logs in reverse order
of set up.
• Remove grate if access is necessary after installation is
complete. (Refer to Section 8.B.)
• Remove two screws on side of pilot shield and remove
shield.
Figure 10.2 Remove Pilot Shield
• Use a phillips screwdriver to remove the two screws
securing the refractory retaining strip. Remove the
refractory side panel and set aside.
Figure 10.3 Loosen Refractory Retaining Strip
Outdoor Lifestyles by Hearth & Home Technologies Inc. • Dakota-AU • 4036-914 Rev H • 6/11
WASHER
• Remove the inside valve access panel by lifting it up and
out.
Figure 10.4 Remove Valve Access Panel
• Use a phillips screwdriver to remove the exterior valve
access panel (remove four screws).
Figure 10.5 Remove Exterior Valve Access Panel
• Loosen lower pressure tap screw before attaching
manometer. Start up the fireplace to verify the pressure
and adjust as necessary. Reverse these steps to
reassemble before log positioning.
Note: Pressure tap screws must be re-tightened.
Figure 10.6 Connect Manometer
21