Setting The Time And Date - Microlife 3BT0-AP Instruction Manual

MLUBPT0-AP-OCT04-1 copy
Comment:
If it is not possible to fit the cuff to your left arm, it can also be
placed on your right arm. However, all measurements should be
made using the same arm.
Comparable blood pressure measurements always require the
same conditions (Relax for several minutes before a reading).

5.4. Setting the time and date

This blood pressure monitor incorporates an integrated clock with date display. Time and
date are recorded along with pressure and pulse. After new batteries have been inserted,
the clock begins to run from the following setting: 2000-01-01 00:00 O'clock.
You must then re-enter the date and current time. Please proceed as follows (Example:
Entering 2002-06-15 Time 09:30 AM):
1. Press the Time button for at least 3 seconds. The display
now indicates the set year, during which the four characters
blink.
2. The correct year can be entered by pressing the MEMORY
button. Once for each change.
(Example: 1 x press).
3. Press the Time button again. The display now switches to
the current date, during which the first character (month)
blinks.
Note: Holding the button down speeds up the procedure.
4. The current month can now be entered by pressing the
MEMORY button.
Example: pressing 6 x advances 6 months)
5. Press the Time button again. The last two characters (day)
are now blinking.
6. The current day can now be entered by pressing the MEM-
ORY button. (Example: 15 x presses advances the day from
the 1st to 15th)
7. Press the Time button again. The display now switches to
the current time, during which the first character (hour)
blinks.
11/24/04 3:14 PM Page 11
Cuff on
right arm
M
M
M
TIME
10