Meter Mode - Lab.gruppen Lake LM 26 Operation Manual

Front Panel Interface
6.8.2 Clip Indication
The dedicated 5-segment metering LEDs (Figure 6-4 ) display Module input and output clip or pre-clip
conditions. Additionally, the faults and warnings LED described in section provides clip warnings for LM 26
input mutes, or GPIO protective mutes, along with confirmation text on the LCD screen.
Clipping is monitored at the following positions in the signal chain:
▸ Analog Inputs: If the input signal exceeds either +12 dBu or +26 dBu (according to analog sensitivity
setting), a clip indication will be given. This does not apply if digital inputs are selected.
▸ Module Inputs: If the signal level at this point exceeds +25 dBu, a clip indication will be given.
▸ Module Outputs: If the signal level at this point exceeds +21 dBu, a clip indication will be given.
6.9

Meter Mode

6.9.1 Home View
The default view when powering on the device is Meter Mode > Home View as shown in Figure 6-5.
Home View provides a summary of Module I/O gain level and limiter gain reduction, along with frame,
module and channel labeling information.
6.9.2 I/O Status View
Pressing the METER button while in Home View results in the I/O Status View being displayed, similar to
that shown in Figure 6-6.
20
LM 26 Operation Manual rev 1.1.8
Figure 6-5: Meter Mode > Home View