Network Cable And Jack - HP EliteBook 8760w Maintenance And Service Manual

Network cable and jack

NOTE: The network cable is included in the Cable Kit, spare part number 652545-001.
Before removing the network cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service access cover (see
6. Remove the optical drive (see
bay hard drive on page
7. Remove the keyboard (see
8. Remove the top cover (see
9. Remove the display assembly (see
10. Remove the fan/graphics board heat sink (see
on page
11. Remove the processor heat sink (see
Remove the network cable:
1. Disconnect the network cable (1) from the system board.
2. Flex the sideband (2).
3. Remove the two Phillips M2.0x3.0 screws (3) that secure the sideband to the base enclosure.
106 Chapter 4 Removal and replacement procedures
Battery on page
Optical drive on page
60).
Keyboard on page
Top cover on page
68).
45).
Service access cover on page
58) or upgrade bay hard drive (see
65).
81).
Display assembly on page
Fan/graphics board heat sink assembly
Processor heat sink on page
46).
85).
73).
Upgrade