Table of Contents
Advertisement
RJ-11 jack cable
NOTE:
The RJ-11 jack cable is included in the Cable Kit, spare part number 641830-001.
Before removing the RJ-11 jack cable, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Service cover (see
b.
Smart Card reader (see
c.
Optical drive (see
d.
Hard drive (see
e.
Modem module (see
f.
Keyboard (see
g.
Base enclosure (see
Remove the RJ-11 jack cable:
1.
Turn the base enclosure right-side up, with the front toward you.
2.
Release the RJ-11 jack from the clip (1) built into the base enclosure.
Battery on page
71), and then remove the following components:
Service cover on page
Smart Card reader on page
Optical drive on page
Hard drive on page
80)
Modem module on page
Keyboard on page
91)
Base enclosure on page
74)
75)
76)
89)
96)
Component replacement procedures
101
Advertisement
Table of Contents
