The Battery Packs; To Charge The Battery Pack - Chicago Electric 66755 Set Up And Operating Instructions Manual

The battery Packs

• Two Battery Packs (1) are included
with this tool kit. They can be used in
combination with the Work Light and
any of the other tools at the same time,
or you can have an extra fully charged
stand-by Battery Pack available for use
when needed.
• Charge both Battery Packs before us-
ing the tools.
• Charge the Battery Pack (1) only with
the 18V Charger (3) provided.
• Charge indoors only.
• If the Battery Pack is hot from use in
a tool, allow time for it to cool down
before Charging.
• If the Battery Pack is hot after charging,
allow time for it to cool down before us-
ing in a tool.

To charge the battery Pack:

Battery Socket (3)
Charger (2)
connect here
Figure 1
1. Insert the Battery Pack (1) into the Bat-
tery Socket (3).
2. Plug the Charger (2) cord into the Bat-
tery Socket (3), then plug the Charger
into an appropriate AC 120V, 60 Hz
power outlet. The red LED light on the
Battery Socket will activate, indicating
the Battery Pack is charging.
3. The initial charge time is 3-5 hours, after
which the Battery Pack should be re-
Page 12
Battery Pack (1)
Release
LED Light
Button
For technical questions, please call 1-800-444-3353.
moved from the Battery Socket/Charger
assembly.
note: When the Charger is plugged into a
power outlet and connected to the Bat-
tery Socket without a Battery Pack at-
tached, the LED will flash from green
to red, and then off. When the Battery
Pack is inserted into the Battery Socket
the LED changes to a solid red. The light
changes to green when the Battery Pack
is fully charged. Do not charge for over
5 hours. Do not place the Charger on
carpeting or near flammables.
4. After each subsequent use, 3 hours of
charging time is needed for the Battery
Pack to be fully charged. However, the
Battery Pack can be left to charge for 5
hours to ensure longer running time in
the tools.
5. If the Battery Pack will not hold a full
charge, discharge batteries by keeping
the tool in the "ON" position until tool
slows or the light begins to dim. Do not
completely discharge batteries. Remove
Battery Pack from tool, allow it to cool,
and charge for 3-5 hours, making sure
not to exceed 5 hours of charging time.
6. When not charging, unplug Charger from
outlet and store in secure location.
7. The batteries contained in the Battery
Pack are nickel-cadmium (Ni-Cd). Do
not dispose of Ni-Cd batteries in house-
hold waste.
8. Follow all local regulations regarding the
proper disposal of Ni-Cd batteries.
9. warning! if the charger cord is
damaged, it must be replaced only by
a qualified service technician.
SKU 66755