Emotiva UPA-500 User Manual page 17

UPA-500
Trigger:
Trigger Input: 5 - 20 V (AC or DC); <10 mA input current required
Trigger Output: 12 VDC; can drive any load up to 50 mA
Power Requirements:
115 VAC or 230 VAC +/- 10% @ 50 / 60 Hz (automatically detected and switched)
Front Panel Controls and Indicators:
Standby; push button (changes color to indicate Standby or On)
Status LEDs (one per channel); illuminate blue for normal operation or red to indicate a fault
(may be disabled by rear panel Status LED switch)
Rear Panel Controls:
AC Power switch; rocker switch (switches AC mains power)
Status LEDs switch; small slide switch on left rear (disables front panel Status LEDs and dims
Standby button halo lighting)
Protection:
The UPA-500 is protected against excessive operating temperature, shorted speaker connections,
ground faults, and other common fault conditions. If a fault occurs, the UPA-500 will return to
Standby mode, the Standby push button will light amber, and the Status LEDs will flash red.
Dimensions:
17" wide x 3.375" high x 16.5" deep (includes feet and binding posts)
Weight:
24 lbs (net); 32 lbs (packaged)
Page 13