Xpa-100 Front And Rear Panels - Emotiva XPA-100 User Manual

XPA-100 Front and Rear Panels

3 4
STATUS LEDS
ON OFF
INPUT OUTPUT
TRIGGER
1. Status Display Window
This window houses two status LEDs. When the XPA-100 is Off or in Standby mode,
neither LED will be lit. When the XPA-100 is powered On, the red LED will illuminate for a
few seconds and then go out, at which point the blue status LED will light. The blue LED will
remain lit in normal operation. If a fault occurs, the red LED will flash and the blue LED will
be extinguished.
Note: The Status LED switch on the rear panel disables the LEDs when set to Off.
2. Standby Button
Press to switch the amplifier On; press again to return to Standby; the halo ring around the
button illuminates amber for Standby and blue for On.
3. Trigger Input and Trigger Output
The XPA-100 is switched On (from Standby) when a trigger signal is presented at the
Trigger Input; the XPA-100 returns to Standby when the trigger signal is removed. When the
XPA-100 is on, a 12 VDC signal is sent from the Trigger Output to control other devices.
XPA-100
1
5 6 7
INPUT
Un-Balanced
Balanced
2
8
OUTPUT
+
_
Page 7
XPA-100
9 10 11
115V 230V
POWER