CrimeStopper COOLSTART RS-830 Installation Instructions Manual page 5

PIN 7: EMPTY / NOT USED
PIN 6: GREEN: (-) START ACTIVATION INPUT & TURBO TIMER INPUT
See descriptions below & diagrams at right:
(-) NEGATIVE START TRIGGER INPUT: a 1-
Second Negative Ground pulse on this wire will
trigger a remote start or stop a remote started
engine. Connect the Green wire to optional
outside sensors such as the RS-400 CoolStart
Temperature/Timer module. This wire can also be
connected to the Negative output channel of an
alarm or Keyless entry system.
TURBO TIMER INPUT: This wire allows the
system to keep a vehicle running for 1-5 minutes
[selectively] after removing the key. This mode
requires the use of a momentary switch that is not
included with the kit. Connect a 2-pole momentary
switch with one side to chassis Ground and the
other side to the Green input wire. If you own a
turbo or turbo diesel vehicle, you can now allow
the CoolStart system to keep your engine running
for 1-5 minutes after exiting/locking your vehicle to
cool-down without the need for an external "Turbo Timer".
NOTE: The turbo timer button will also trigger a remote start if it is inadvertently pressed when the vehicle is
not running. Please note this when installing the button and choose a location out of harm's way
PIN 5: GRAY: (-) NEGATIVE HOOD PIN SWITCH (REQUIRED FOR PROGRAMMING)
Connect the Gray wire to a switch that is at ground when the hood is open. If an existing switch is not available, then we
recommend installing the supplied pin switch. When this wire is grounded, (hood is open) the remote start is inhibited.
The hood pin is required for option and remote transmitter programming. If installing the supplied pin switch find a
location around the perimeter of the engine compartment. Try not to mount pin switches in water pathways. A small
Brown wire is included in the kit when connecting the pin switch.
WIRING
Auxiliary Start Input
GREEN
1 sec. (-) pulse
Turbo Timer Mode
GREEN
5
AFTERMARKET
ALARM / KEYLESS
(Aux Channel
Output)
or
TEMP SENSOR
Momentary
Switch
(Not included)