connection
* Standard voltage for camera operation : DC 12V ±10%, AC 24V ± 10%
* There may be some deviation in voltage drop depending on the type of wire and the
manufacturer.
Be sure to connect power only after all the installation is complete.
M
Note that DC adaptor is not supplied with camera.
Ground should be connected to the GND terminal.
USING COAXIAL COMMUNICATIONS
Coaxial Communications System
OSD Control method
CAMERA
SET
UP
DOWN
LEFT
RIGHT
- Video Cable
The camera's video output port is connected to the monitor with a BNC coaxial
cable, shown below : If the distance between the camera and the monitor exceeds
the recommended maximum, please use an auxiliary video amp.
If the camera is controlled through coaxial communication, please use a video amp intended for
M
coaxial communications. Regular video amps do not transfer coaxial signals.
16_ connection
DVR
MENU/ENTER
UP KEY
DOWN KEY
LEFT KEY
RIGHT KEY
DVR
DVD RECORDER
Distance
300m
450m
600m
CONTROLLER
OSD KEY
JOYSTICK UP
JOYSTICK DOWN
JOYSTICK LEFT
JOYSTICK RIGHT
: BNC
•
• ---- : RS-485
Recommended Cable Specifi cation
3C2V(RG-59/U)
5C2V(RG-6/U)
7C2V(RG-11/U)
s
M
M
U