3.13 Adjust sensibility of label gap
detection transmission sensor
If the gap between labels are not being detected accurately, adjust the
sensibility as follows.
(1)
Set the sensor label sheet.
(2) Perform self test.
(3) When the self test printing starts, press the FEED button for more
than 3 seconds during the time it takes to finish printing.
(4) When the
button again. The reception level of the sensor located at the label
and gap section will be printed out as a graph and the sensibility
adjustment will be completed.
********************************
Entering Factory Test mode
********************************
sign has been printed, press the FEED
35