Cisco ASA 5505 Hardware Installation Manual page 30

Rack or Wall Mounting the Cisco ASA 5505
Figure 3-10
1
2
3
2
1
M3 x 12 screws
2
Plastic anchors
Drill a hole on the wall at each mark you made for the location for the plastic anchors.
Step 3
Press the four plastic anchors into the holes.
Step 4
Screw the four screws provided in the accessory kit into the anchors, but not all the way. Allow them to
Step 5
protrude about 1/8-inch (0.317 cm).
You must apply three tamper evident labels. Tamper evident labels are inclued in the FIPS kit,
Cisco-FIPS-KIT=. Clean the chassis of any grease, dirt, or oil before applying the tamper evident labels.
Alcohol-based cleaning pads are recommended for this purpose.
Apply the first tamper evident label as shown in
Step 6
Figure 3-11
POWER
1
Tamper label
Cisco ASA 5505 Adaptive Security Appliance Hardware Installation Guide
3-12
Bottom View of the FIPS Enclosure
3
Plastic anchors for vertical mounting (optional)
Cisco ASA 5505 Tamper Evident Label Placement
1
48
VDC
7
POWER over ETHERNET 6 5 4
1
Figure 3-11.
Security
Services
Card Slot
3 2 1 0
Chapter 3 Installing the Cisco ASA 5505
1
2
3
2
Console
1
RESET
2
OL-18362-01