Cisco Video Surveillance 2621 IP Dome User Manual page 36

Performing the Initial Setup of the IP Camera
Procedure
Step 1 Start Internet Explorer, enter HTTPS://ip_address in the address field, and press Enter.
Replace ip_address with the IP address that the IP camera obtained through DHCP or, if the camera is
unable to obtain this IP address, enter 192.168.0.100.
The Account window appears.
Step 2 In the Set Password and Verify Password fields in the Admin column, enter a password for the IP camera
administrator.
You must enter the same password in both fields. The password is case sensitive and must contain at least
eight characters, which can be letters, numbers, and special characters, but no spaces. Special characters
are: ! " # $ % & ' ( ) * + , - . : ; < = > ? @ [ \ ] ^ _ ` { | } ~.
In the Set Password and Verify Password fields in the Root column, enter a password that is used when
Step 3
accessing the IP camera through a Secure Shell (SSH) connection.
You must enter the same password in both fields. The password is case sensitive and must contain at least
eight characters, which can be letters, numbers, and special characters, but no spaces. Special characters
are: ! " # $ % & ' ( ) * + , - . : ; < = > ? @ [ \ ] ^ _ ` { | } ~.
You use the root password if you need to troubleshoot the IP camera through a SSH connection with the
assistance of the Cisco Technical Assistance Center.
Step 4 In the HTTP area, click the HTTP radio button if you want to allow both HTTP and HTTPS connections
to the IP camera.
The default setting is HTTPS, which allows only HTTPS (secure) connections to the IP camera.
Step 5 Click Apply.
The IP camera reboots.
After the IP camera reboots, start Internet Explorer and, in the Address field, enter the following:
Step 6
protocol://ip_address
where:
protocol is HTTPS or HTTP. (You can use HTTP only if you enabled it in
•
ip_address is the IP address that you used in
•
If you are prompted to install ActiveX controls, which are required to view video from the IP camera,
Step 7
follow the on-screen prompts to do so.
The Main window appears and video from the IP camera starts playing automatically.
You can take these actions in the Main window:
Click the Setup link to access configuration menus for the camera. For detailed information about
•
these menus, see
Click the Home link to view and control live video from the camera. For detailed information about
•
these actions, see
Click the Logout button to exit the window.
•
Cisco Video Surveillance System 2621 IP Dome User Guide
2-24
Chapter 3, "Configuring and Managing the IP Camera."
Chapter 4, "Viewing Live Video."
Step 1.
Chapter 2 Getting Started
Step 4.)
OL-24129-02