Cisco Video Surveillance 2621 IP Dome User Manual page 25

Video surveillance 2621 ip dome
Table of Contents

Advertisement

Chapter 2
Getting Started
(Optional) Use the GPIO ports to connect external devices that trigger alarms (connect through alarm
Step 12
input ports) or respond to alarms (connect through alarm output ports).
See
Figure 1-1 on page
Attach the camera unit to the base plate by aligning the three tabs on the camera unit with the slots on
Step 13
the base plate, pressing the camera unit into the base plate until the tabs snap into place, and securing
the camera unit with the two camera unit screws (see
Figure 2-9
1
Base plate
2
Camera unit
See
Figure 2-16 on page 2-27
Step 14
image:
Temporarily attach an analog monitor to the IP dome so that you can see video while adjusting the
camera. If the cable from the monitor terminates with a 3.5 mm jack, plug it into the analog video
output port on the IP dome. If the cable terminates with a BNC connector, connect it to the mini
cable with BNC adapter, then plug the cable into the analog video output port. The mini cable with
BNC adapter is included in the audio/video cables accessory kit, which you can purchase from Cisco
(Cisco part number CIVS-IPCA-1017=).
OL-24129-02
1-3.
Attaching the Camera Unit to the Base Plate
and take these actions to adjust the camera lens to obtain the desired
Installing the Cisco Video Surveillance 2621 IP Dome
Figure
2-9).
Cisco Video Surveillance System 2621 IP Dome User Guide
2-13

Advertisement

Table of Contents
loading

This manual is also suitable for:

Civs-ipc-2621v

Table of Contents