Mounting With A Junction Box - Cisco Video Surveillance 2621 IP Dome User Manual

Installing the Cisco Video Surveillance 2621 IP Dome

Mounting with a Junction Box

You can mount the IP dome onto a standard 4 x 4 inch (101.6 x 101.6 mm) junction box. To do so,
perform the following steps.
When you disassemble the IP dome for mounting as described in these steps, make sure to remove any
Note
protective packing material that is installed between components.
Procedure
Step 1 Remove the dome assembly by unscrewing the three security TORX screws and pulling the dome away
from the base plate (see
Use the TORX screwdriver that is provided with the IP dome to unscrew these screws.
Cisco Video Surveillance System 2621 IP Dome User Guide
2-4
Drill bits (required for surface mounting with a conduit base, mounting to a ceiling tile, or
–
mounting directly on a solid surface).
One bit should be the appropriate size for the mounting hardware that you are using. The other
bit should be large enough for a hole that accommodates the cables that will attach to the IP
dome.
Cutting tool to cut a rectangle for cable access (required for mounting directly on a ceiling tile
–
or solid surface).
Screws (quantity 4) for attaching the conduit to a surface (required only for the conduit base
–
mounting option).
Figure 2-2).
Chapter 2 Getting Started
OL-24129-02