Table of Contents
Advertisement
Message
Card full.
Card full.
Cannot execute.
Card is not formatted.
Format the card now?
CHECK DISC
Control Information
Error.
COPY PROTECTED
DISC ACCESS
DISC ALMOST FULL
Disc error has occurred.
Finalizing is not
complete.
Disc error has occurred.
Format the disc now?
Disc error has occurred.
Formatting is not
complete.
Disc error has occurred.
Keep disc inside &
restart.
162
Cause & Troubleshooting
Delete unnecessary stills and try the card, or use another card.
No more recording on this card can be done: Delete unnecessary
stills or use another card.
Delete unnecessary stills and try the card, or use another card.
Was the card formatted on PC? When using the card on this DVD
video camera/recorder, choose "YES" and format it.
A disc unusable on this DVD video camera/recorder may have
been inserted or the disc may be damaged.
Make sure that the type of disc is correct, and make sure that the
disc is not write-protected.
Mismatch may occur between the recorded image and scene
information.
Update the control information.
• Use another disc.
• See *3 on page 166.
The video signal input to this DVD video camera/recorder may be
copy-guarded.
Some prerecorded video materials, such as movies, are guarded
against copying.
Copy-guarded materials cannot be recorded on this DVD video
camera/recorder.
The recorded scene is being stored on disc.
Wait until the message disappears, and you can start to use the
DVD video camera/recorder.
This DVD video camera/recorder is verifying whether the correct
disc has been inserted.
Wait until the message disappears, and you can start to use the
DVD video camera/recorder.
Remaining free space on disc is less than 1 minute of video or 10
photos: Delete unnecessary scenes or use another disc.
• Disc error occurred during finalizing, and finalizing failed.
Replace the disc.
• See *3 on page 166.
• Has the disc been initialized on PC? Has initializing the disc on
PC been interrupted?
Choose "YES" and initialize the disc when using it on this DVD
video camera/recorder. Initializing the disc will erase all data on
it.
• See *2 on page 166.
The disc may be dirty.
Remove the disc and wipe off fingerprints, dust, etc. before
reusing it, or use another disc.
This message may also appear if you insert a disc for which
formatting was interrupted midway. In this case, use another disc.
Disc error could have occurred during editing of scenes.
Turn off the DVD video camera/recorder with the disc being used
in it, connect AC adapter/charger, and then power the DVD video
camera/recorder again. Repair of scenes will be tried.
Reference
page
29, 110
29, 110
132
25, 133
134
24, 26
80
49, 51
158
28, 110
135
132
26, 132
43
Advertisement
Table of Contents
