Wake On Lan - Buffalo TeraStation User Manual

Wake on LAN

The TeraStation supports Wake on LAN, which allows it to be turned on remotely.
Before using Wake on LAN, enable it as described below.
1
In the Web Admin interface, navigate to [Network] - [Settings] - [IP Address Settings]. Click [Modify Settings].
2
Wake on LAN is now enabled. As long as it is connected to power and the network, you can turn on the TeraStation re-
motely. To turn the TeraStation on remotely, send a Wake on LAN packet to the TeraStation on UDP port 2304.
Notes:
• TS-XEL series TeraStations do not support Wake on LAN.
• After receiving the Wake on LAN packet, the TeraStation may take approximately five minutes to be ready to use.
• After power is restored from a power outage, wait five minutes before sending a Wake on LAN packet to the TeraSta-
tion.
• To use Wake on LAN, you'll need Wake on LAN software such as AMD's Magic Packet utility. The TeraStation does not
include Wake on LAN software.
• The TeraStation does not support using Wake on LAN and port trunking at the same time. You may use either feature,
but not both at the same time.
• On the local network, Wake on LAN packets may be sent to port 2304 on either of the TeraStation's LAN ports. If the
TeraStation is connected to a Buffalo wireless router configured for remote access, then it may be turned on from out-
side the local network (from the WAN side). To use this feature, the Buffalo router must be connected to LAN Port 1 only
on the TeraStation. The TeraStation does not support remote WAN-side Wake on LAN if LAN Port 2 is connected to the
router.
TeraStation User Manual
1 Click [Enable] for [Wake on LAN].
2 Click [Save].
105