Dell PowerEdge 2450 Installation And Troubleshooting Manual page 55
Dell poweredge 2450 system
Hide thumbs
Also See for PowerEdge 2450:
- Hardware install manual (32 pages) ,
- Supplementary manual (30 pages) ,
- Information update (12 pages)
Table of Contents
Advertisement
support.dell.com
securing lever
power LED
expansion-card cage
4.
Locate the expansion-card cage securing lever (see Figure 7-3). Rotate the lever
upward until it stops in an upright position.
5.
Lift the expansion-card cage up and away from the chassis.
To replace the expansion-card cage, perform the following steps:
1.
With the securing lever in the upright position, lower the expansion-card cage
into place until it is aligned.
2.
Rotate the securing lever downward until it is flush with the top of the chassis.
Make sure the riser board is fully seated in the RISER connector on the system
board.
3.
Reconnect any cables you removed in step 3 of the previous procedure, "Remov-
ing the Expansion-Card Cage."
"
In Figure 7-4, the computer doors are opened to provide an interior view. Refer to this
illustration to locate interior features and components discussed later in this guide.
Checking Inside the Computer
7-5
Advertisement
Table of Contents
Troubleshooting
