Dell PowerEdge 2450 Installation And Troubleshooting Manual page 25

   



NOTE: For the full name of an abbreviation or acronym used in this table, see "Abbreviations and Acronyms."
support.dell.com

Improperly seated DIMMs or
faulty keyboard/mouse controller
chip (defective system board)
Microprocessor not supported by
system
Microprocessor not supported by
BIOS
RAID DIMM not supported by
system
RAID hardware key not supported
by system
<F10> key was pressed during
POST , but no utility partition
exists on the boot hard-disk drive
Type of controller has changed
since previous system boot
Faulty diskette or hard-disk drive
   
Remove and reseat the DIMMs.
If the problem persists, replace
the DIMMs. If the problem still
persists, replace the system
board. See Chapter 11, "Getting
Help," for instructions on obtain-
ing technical assistance.
Install a correct version of the
microprocessor in the specified
microprocessor connector.
Upgrade the BIOS. See
Chapter 4, "Using the System
Setup Program," in the User's
Guide for instructions.
Install a correct version of the
RAID DIMM.
Install the RAID hardware key for
your specific system.
Create a utility partition on the
boot hard-disk drive. See "Using
the Dell OpenManage Server
Assistant CD" in your User's
Guide.
Back up information on the drives
before changing the type of con-
troller used with the hard-disk
drives.
Replace the diskette or hard-disk
drive.
Messages and Codes 3-9