Changing Boot Sequence For Future Boots; Clearing Forgotten Passwords - Dell Dimension 5150 Service Manual

NOTE: To boot to a USB device, the device must be bootable. To make sure your device is bootable, check the device
documentation.

Changing Boot Sequence for Future Boots

1. Enter system setup (see
2. Use the arrow keys to highlight the Boot Sequence menu option and press <Enter> to access the menu.
NOTE: Write down your current boot sequence in case you want to restore it.
3. Press the up- and down-arrow keys to move through the list of devices.
4. Press the spacebar to enable or disable a device (enabled devices have a checkmark).
5. Press plus (+) or minus (–) to move a selected device up or down the list.

Clearing Forgotten Passwords

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in
the Product Information Guide.
1. Follow the procedures in
2. Locate the 3-pin password jumper (PSWD) on the system board (see
Entering System Setup).
Getting Started.
System Board Components), and attach the