Replacing The Hard Disk Drive Or Solid-State Drive - ThinkPad X140e User Manual

4. Insert a fully charged battery until it clicks into place
position 2 .
5. Turn the computer over again. Connect the ac power adapter and all cables.

Replacing the hard disk drive or solid-state drive

Before you start, print these instructions.
Attention: The hard disk drive or solid-state drive is very sensitive. Incorrect handling can cause damage
and permanent loss of data. Observe the following guidelines:
• Replace the hard disk drive or solid-state drive only if you upgrade it or have it repaired. The connectors
and slot of the hard disk drive or solid-state drive are not designed for frequent changes, or drive
swapping.
• Do not drop the drive or subject it to physical shocks. Put the drive on a material, such as soft cloth, that
absorbs any physical shocks.
• Do not apply pressure to the cover of the drive.
• Do not touch the connector.
• Before removing the hard disk drive or solid-state drive, make a backup copy of all the information
on it, and then turn the computer off.
• Never remove the drive while the computer is operating, in sleep mode, or in hibernation mode.
To replace the hard disk drive or solid-state drive, do the following:
1. Turn off the computer; then disconnect the ac power adapter and all cables from the computer.
2. Close the computer display, and turn the computer over.
3. Remove the battery. See "Replacing the battery" on page 57.
1 , and then slide the battery latch to the locked
Chapter 6
59
.
Replacing devices