Table of Contents
Advertisement
2
PANEL DESCRIPTION
C.TONE CH ENT KEY "TSEL"
Push to enter the continuous tone channel selection mode.
Then push [CH Up] or [CH Down] to select the desired tone
frequency/code setting. The selected channel remains set as
a continuous tone channel until another channel is designat-
ed as such.
TALK AROUND KEY "TA"
Push to turn the talk around function ON or OFF.
• The talk around function equalizes the transmit frequency to the
receive frequency for transceiver-to-transceiver communication.
WIDE/NARROW "W/N"
Push to switch the IF bandwidth between wide and narrow.
• The wide passband width is preset to either 25.0 or 20.0 kHz by
your dealer (PMR operation only).
DTMF AUTODIAL KEY "DTMA"
Push to enter the DTMF channel selection mode. Then push
[CH Up] or [CH Down] to select the desired DTMF channel.
After selecting the DTMF channel, push again to transmit the
selected DTMF code.
RE-DIAL KEY "DTMR"
Push to transmit the last-transmitted DTMF code.
9
CALL KEYS "CALL" "CALA" "CALB"
Push to transmit a 2/5-tone or BIIS ID code.
• A Call transmission may be necessary before you call another sta-
tion, depending on your signaling system.
• [Call A] and/or [Call B] may be selectable when your system
employs selective 'Individual/Group' calls. Ask your dealer which
call is assigned to each key.
EMERGENCY KEY "EMR"
Hold down to transmit an emergency call.
• The emergency call transmits and beep sounds. The display does
not change.
• The transceiver can transmit the emergency call silently, or with the
display changing, depending on the presetting. Ask your dealer for
details.
• If you want to cancel the emergency call, hold down the key again
before transmitting it.
• The emergency call is transmitted only one time, or repeatedly until
receiving a control code, depending on the presetting.
SURVEILLANCE KEY "SURV"
Push to turn the surveillance function ON or OFF.
When this function is turned ON, a beep is not heard and the
LCD backlight and BUSY indicator do not light when a signal
is received or a key is pushed.
TX CODE ENTER KEYS "TXCE"
Push to directly enter the ID code edit mode, for both 5-tone
and MSK. Then push [CH Up] or [CH Down] to set the desired
digit. (p. 15)
Advertisement
Table of Contents
