Zone Control - Daikin BRC230Z4 Operation Manual

For ZONE control, select the rooms you wish to heat or cool.
■
To select ZONE
1
2
■
To cancel ZONE selection
1
2
NOTE
● Not all the buttons are available, depending on the number of zones installed. If a zone button not
corresponding to any zone is pressed, the green LED will not be lit. Zones that are not required
must be set up during the commissioning of the controller.
● You can register a name for each zone. For the method of registering, refer to the section of name
registration. (page 19.)

ZONE Control

Press "
button".
● Select the desired ZONE number you wish to
switch on.
● "
" is displayed on the LCD.
Press "
button" again.
● The selected zone is fi xed.
● The LED on the remote controller lights up green.
● When operation is started, air is blown to the
selected zone.
● For other zones, use the same procedure for setting.
Press " button".
● Select the ZONE number for which you wish to
switch off.
● "
" is displayed on the LCD.
Press "
button" again.
● The selection is canceled.
● The green LED on the remote controller goes out.
● For other zones, use the same procedure for setting.
17
OPERATION