Using Cleanjet - Henny Penny CLIMAPLUS LCS Applications Manual

CLEANING
CLEANJET
CLEANJET
STEP 0
55

Using CleanJet

ClimaPlus Combis are now equipped with CleanJet, a unique, patented
system that cleans and rinses the cabinet interior with no labor or supervision
whatsoever.
The CleanJet cleaning arm
The special CleanJet arm attaches to the inside of the cabinet and lays down a
powerful "vortex" spray pattern that works in conjunction with high heat and timed
cleaning stages to completely clean and rinse the combi.
Dispensing detergent and rinsing agent
CleanJet detergent and rinsing agent are dispensed automatically in the proper
amounts, depending on the cleaning cycle selected.
On base-top models, a special drawer dispenser slides out from under the unit
to be filled, then slides back under to engage and store.
On floor models, detergent and rinsing agent containers are connected with a
hose directly to the ClimaPlus.
To begin the automatic CleanJet cleaning:
1. Be sure unit is turned off and cabinet has cooled to 150°F (83°C) or below.
2. For base top units, be sure dispensing drawer has sufficient detergent and
rinsing agent. For models 20 and 40, be sure detergent and rinsing agent
containers are properly connected with the connecting hose to the appropriate
nozzles located under the front edge of the unit to the left of the handshower.
3. Connect CleanJet arm to the fixture inside the cabinet on the back wall. Floor
models 20 and 40 require two CleanJet arms (included.)
DO NOT place soiled racks, pans or grids in cabinet for cleaning
when using CleanJet. CleanJet arm could be damaged during operation.
4. Close door.
DO NOT open door while cycle is in progress. CLEANJET
CYCLE WILL NOT STOP IMMEDIATELY.
5. Turn unit on. "CLEANJET" appears in the TIMER display. "STEP 0"
or "STEP 1" appears in the IQT display.
6. Use the Central Dial to select the desired cleaning stage based on the condition
of the cabinet. CleanJet offers a total of seven cleaning programs, steps 0-6, and
QUICK".
NOTE: If you do not find "Step O" or "Step 5" and "Step 6" in the display,
it is because they must first be copied into the CleanJet menu by means of
another method of access. This will only need to be done once. To make Step
0 or Steps 5 and 6 available in the CleanJet display, follow the procedure below:
®