Table of Contents
Advertisement
AXIS Q6032-C PTZ Dome Network Camera
Hardware Overview
NOTICE
NOTICE
NOTICE
To prevent corruption of recordings, the SD card should be unmounted before removal. To unmount, go to Setup > System
Options > Storage > SD Card and click Unmount.
Control button - The control button is used for:
•
Connecting to an AXIS Video Hosting System service. See page 43. To connect, press and hold the button for
about 1 second until the Status LED flashes green.
•
Connecting to AXIS Internet Dynamic DNS Service. See page 43. To connect, press and hold the button for
about 3 seconds.
•
Resetting the product to factory default settings. See page 50.
Power button - Press the power button to temporarily power the product when the dome cover is removed. The power button is also
used with the control button to reset the camera to factory default settings. See page 50.
Multi-connector - Terminal connector for connecting the supplied media converter switch, which provides the following signals:
•
DC Power
•
Network (Ethernet 10/100Base-T)
•
Input/Output (I/O)
The supplied multi-connector cable is required in order to maintain the product's IP rating, see Multi-Connector Cable, on page 58.
LED Indicators
Color
Indication
Unlit
Connection and normal operation
Amber
Steady during startup. Flashes during firmware upgrade.
Amber/red
Flashes amber/red if network connection is unavailable or lost.
Red
Flashes red for firmware upgrade failure.
Green
Shows steady green for 10 seconds for normal operation after restart.
6
Advertisement
Table of Contents
