Table of Contents
Advertisement
AXIS Q6032-C PTZ Dome Network Camera
Events
Events
The Axis product can be configured to perform actions when different events occur, for example, start a recording when motion is
detected. The set of conditions that defines how and when the action is triggered is called an Action Rule.
Available Action Rule triggers and conditions include:
•
Applications — use installed applications to trigger the rule, see Applications, on page 34.
•
Detectors
-
Motion Detection — trigger the rule when motion is detected, see Motion Detection, on page 32.
•
Hardware
-
Open Casing Detection — trigger the rule if the casing of a connected external device, such as a junction
box or cabinet (not included), is removed or opened. This can for example be used to send notifications of
maintenance or unauthorized tampering.
-
Network — trigger the rule if network connection is lost or restored. This can for example be used to start
recording to the SD card.
•
Input Signal
-
Manual Trigger — trigger the rule using the Manual Trigger button in the Live View page, see Controls on
the Live View Page, on page 12. This can for example be used to validate actions during product installation
and configuration.
•
PTZ
-
Autotracking — trigger the rule when autotracking starts or stops, see Autotracking, on page 28.
•
Storage
Available — trigger the rule when the storage device is unmounted or removed. This can for example be
-
used to send maintenance notifications.
Full — trigger the rule when the storage device is full. Under normal operation, the oldest recordings will be
-
overwritten to prevent the storage device from becoming full.
Locked — trigger the rule if the storage device is locked (write protected).
-
System
•
-
System Initializing — trigger the rule when the product is being started. This can for example be used to send a
notification when the product restarts.
•
Time
-
Recurrence — trigger the rule periodically, see Recurrences, on page 37. This can for example be used to upload
an image every 5 minutes.
-
Use Schedule — trigger the rule according to the selected schedule, see Schedules, on page 37.
Available actions include:
•
PTZ Control
-
Autotracking — start autotracking, see Autotracking, on page 28.
-
Preset Position — go to a preset position.
-
Guard Tour — start a guard tour, see Guard Tour, on page 29.
35
Advertisement
Table of Contents
