Operating The Remote Control; Power; Auto -Restart; Cooling Mode - EdgeStar AP8000W Owner's Manual

Power

Cooling Mode

NOTE: The exhaust hose
must be used in Cooling
mode in order to cool a
room.

Dehumidifying Mode

NOTES: If the room temperature is below 77ºF, the fan will always run on low speed while in the
Dehumidifying mode. If you do not use the exhaust hose in Dehumidifying mode, you must manually drain
the water from the unit. Additionally, the ambient temperature in the room will probably rise by a few
degrees if you do not use the exhaust hose. You will be not be able to change the thermostat temperature
or fan speed while in Dehumidifying Mode.
13

Operating the Remote Control

Use the Power button to turn the portable air conditioner on and off.
By default when you first use the power button, the unit will begin to
operate in cooling mode. The unit will remember the last used
mode/settings if you shut down and restart.
Auto-Restart: If power to the unit is interrupted, the air conditioner will
restart itself in its last used mode/settings once power is restored. The
compressor will restart after 3 minutes.
Cooling mode cools and dehumidifies the air. If the ambient temperature
drops below the temperature you selected, the compressor turns off and
the unit functions with the fan only. When the temperature rises above the
temperature you selected, the compressor turns on again.
Whether your desired temperature can actually be reached depends on
the ambient conditions. The room temperature remaining above the set
temperature is normal.
To operate the unit in cooling mode:
1) Make sure the power cord is plugged into a power outlet.
2) Press the Power button on the remote.
3) Press the Mode button until the Mode Indicator Light on the Control
Panel turns blue.
4) Select the fan speed by using the Speed button.
5) Set the thermostat by using the Up and Down buttons. The thermostat is
adjustable between 61°F - 89°F in one degree increments. You can switch
between Fahrenheit and Celsius by pressing the ºC / ºF Button
During the Dehumidifying mode, the unit will condense water out of the
air and exhaust it through the exhaust hose. The ambient temperature in
the room will probably drop by a few degrees while using the
Dehumidifying mode.
To operate the unit in dehumidifying mode:
1) Make sure the power cord is plugged into a power outlet.
2) Press the Power button on the remote.
3) Press the Mode button until the Mode indicator light turns amber on the
Control Panel.