Sony Handycam DCR-HC62 Operating Manual page 69

A rippling effect appears on the LCD
screen when you touch it.
• This is not a malfunction. Do not press hard
on the LCD screen.
The battery pack discharges too
quickly.
• Ambient temperature is too high or too low,
or the battery pack has not been charged
enough. This is not a malfunction.
• Fully charge the battery again. If the
problem persists, the battery may be worn-
out. Replace it with a new one (p. 12,81).
-4
...
Q
=
!2:
CD
rn
::::r
Q
Q
:::
=
CCI
•
Menu items are grayed out.
• You cannot select grayed items in the
current recording/playback situation.
The buttons on the touch panel do
not work correctly or do not work at
all.
• Adjust the touch panel ([CALIBRAnOND
(p.85).
Ip-MENUI
is not displayed.
• During Easy Handycam operation, not all
menu items are functional. Cancel Easy
Handycam operation (p. 20).
You cannot turn off the indicator.
• You cannot tum off
LU .
Touch
LU
to
check the warning messages (p. 76).
The buttons do not appear on the
touch panel.
• Touch the LCD screen lightly.
• Press DISPIBAIT INFO on your
camcorder (or DISPLAY on the Remote
Commander) (p. 91,93).
The remaining battery time indicator
does not indicate the correct time.
• Ambient temperature is too high or too low,
or the battery pack has not been charged
enough. This is not a malfunction.
• Fully charge the battery again. If the
problem persists, the battery may be worn-
out. Replace it with a new one (p. 12,81).
• The indicated time may not be correct in
certain circumstances. For example, when
you open or close the LCD panel, it takes
about 1 minute to display the correct
remaining battery time.
The CHG (charge) lamp flashes while
the battery pack is being charged.
• Attach the battery pack to the camcorder
correctly (p. 12). If the problem persists,
disconnect the AC Adaptor from the wall
outlet (wall socket) and contact your Sony
dealer. The battery pack may be worn-out.
The CHG (charge) lamp does not
light while the battery pack is being
charged.
• Slide the POWER switch to OFF (CHG)
(p.
12).
• Attach the battery pack to the camcorder
correctly (p. 12).
• Connect the power cord (mains lead) to the
wall outlet (wall socket) properly.
• The battery charge is completed (p. 12).
The power abruptly turns off.
• When approximately 5 minutes have
elapsed while you do not operate your
camcorder, the camcorder is automatically
turned off (A.SHUT OFF). Change the
setting of [A.SHUT OFF] (p. 52), or tum
on the power again (p. 15), or use the AC
Adaptor.
• The battery is fully discharged, or almost
discharged. Charge the battery pack (p. 12).
Continued"
69