Table of Contents
Advertisement
Side
VCR
DVD PLAYER
CAMCORDER
VIDEO GAME
DAILY USE
SWITCHING ON TV SET
1) If stand-by indicator (B2) is red, then the TV set
is in stand-by mode.
You can switch on using the remote control
POWER button (A1), the NUMBER 0....9 but-
tons (A3), or PROGRAM UP (A6) / DOWN (A21)
buttons.
The side panel PROGRAM UP/DOWN buttons
(B5) can also be used.
Once on, the power indicator (B4) turns to green
and the picture appears on the screen.
SWITCHING OFF TV SET
Remark: If a broadcast signal is not present after 30 minutes, the TV set will be automatically turned to stand-by mode.
TV/AV SELECTION
Allows to switch between TV and external modes.
By repeatedly pressing the remote control TV / AV (A5) or the TV side panel TV /
AV (B7) button, the on-screen display is changed as shown :
AV1
AV2
S-VIDEO 2
AV3
S-VIDEO 3
Remark: If the signal source from the rear SCART1 socket (AV1) is RGB (e.g.
normally from a DVD player) then AV1 RGB will be displayed.
Connect the S-VIDEO or VIDEO terminal.
Video
OUT
Audio
OUT
S-Video
OUT
2) If stand-by indicator (B2) is not lit, then the TV
set is powered off.
You must press the TV set front panel MAIN
POWER button (B1).
If a picture does not appear, then the stand-by
indicator will be lighted red.
In this case, use the remote control as indicat-
ed in 1).
1) Pressing the remote control POWER button (A1),
you can switch off to stand-by mode (low pow-
er consumption mode) which also allows quick
restart by remote control (see above: SWITCH-
ING ON TV SET).
TV
Side AV SOCKET (AV3)
The side AV socket (B9) - (B10) has audio and video
inputs. To switch from TV to these inputs, use the
TV / AV buttons (A5) or (B7) and select AV3.
Side S-VIDEO JACK
The side S-VIDEO jack (B11) has video inputs
only. It is necessary to connect the audio inputs
to socket (B10) in order to have audio and video.
To switch from TV to these inputs, use the TV / AV
buttons (A5) or (B7) and select S-VIDEO3.
HEADPHONE SOCKET
To hear TV sound with headphones, insert a
3.5mm headphone plug into the headphone
socket (B12). The speaker's sound will be auto-
matically cut off.
3) If stand-by (B2, red) and power indicator (B4,
green) blink alternately then the TV set is in
child-lock mode. It is necessary to use the re-
mote control POWER button (A1), NUMBER 0....9
buttons (A3), or PROGRAM UP (A6) / DOWN
(A21) buttons.
The side panel PROGRAM UP/DOWN buttons
(B5) will not function.
Once on, the power indicator turns to green
and the picture appears on the screen.
2) Pressing the TV set front panel MAIN POWER
button (B1), you can completely power off the
TV set.
In this case, you must use the same front pan-
el POWER button (B1) to switch on again (see
above: SWITCHING ON TV SET).
6
Advertisement
Table of Contents
