Table of Contents
Advertisement
Getting started
Telephone base and charger installation
Install the telephone base and charger as shown below.
The telephone base is ready for tabletop use. If you want to change to wall
mounting, see Installation options on page 9 for details.
Telephone base installation
Plug one end of the
telephone line cord into a
telephone jack or a DSL filter.
Route the telephone line
cord through this slot.
Raise the antenna.
Plug the other end of the
telephone line cord into the
telephone jack on the back
of the telephone base.
Charger installation
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required.
The DSL filter must be plugged
into the telephone wall jack.
Plug the small end of the telephone base power adapter into
the power adapter jack on the back of the telephone base.
Plug the power adapter into an electrical outlet not
controlled by a wall switch.
IMPORTANT INFORMATION:
•
Use only the power adapter(s) provided with this
product. To obtain a replacement, visit our website at
www.telephones.att.com
1 (800) 222-3111
1 (866) 288-4268
•
The power adapters are intended to be correctly oriented
in a vertical or floor mount position. The prongs are not
designed to hold the plug in place if it is plugged into a
ceiling, under-the-table or cabinet outlet.
. In Canada, dial
.
6
Plug the large end
of the telephone
base power adapter
into a power outlet
not controlled by a
wall switch.
Route the power adapter
cord through this slot.
or call
Hide quick links:
Advertisement
Table of Contents
