Getting Started; Panel Layout; Ps110 Panel Layout - Sena PS110 User Manual

2. Getting Started

This chapter describes how to set up and configure the Pro Series.
- 2.1 Panel Layout explains the layout of the panel and LED indicators.
- 2.2 Connecting The Hardware describes how to connect the power, the network, and the
equipment to the Pro Series and how to access the console port using a serial console or a
Telnet from remote location..
- 2.3 Accessing The Web Browser Management Interface describes how to access Web menu
from remote location.
The following items are required to get started.
- One power cable (included in the package)
- One Serial data cable (included in the package)
- One Ethernet cable
- One PC with Network Interface Card (hereafter, NIC) and/or one RS232 serial port.

2.1. Panel Layout

2.1.1. PS110 Panel Layout

The PS110 has four LED indicator lamps for status display. Upper-left lamp indicates the system
power-on status. Lower-left lamp indicates the 10/100Base Ethernet Link status. Right two lamps
indicate Receive and Transmit of the serial port.
There is a factory reset switch bottom panel of PS110 and the user can use this switch to restore
factory default configuration.
There is also a DIP switch located next to the Ethernet connector to set communication type of serial
port. (Please refer to Section 4.2.6. Serial Port Parameters and Appendix 1. Connections for more
detail information of serial communication type and its connection)
User can also select console or data mode of serial port using the Data/Console switch located next to
the serial port. (Please refer to Section 2.2.5. Using The System Console for more detail information of
serial console access)
Lamps
Status Power
Ethernet
Ready
Serial port Rx
Tx
Table 2-1 LED indicator lamps of the PS 110
Function
Turned on to RED if power is supplied
Turned on to GREEN if system is connected to Ethernet network.
Blinks whenever there is any incoming data stream through the serial port of
the PS110
Blinks whenever there is any outgoing data stream through the serial port of
the PS110
12