Controlling Via The Embedded Web Pages; Connecting To The Vp-4X8Ak Via Your Browser; Figure 15: Java Test Page Success Message; Figure 16: Entering The Ip Number In The Address Bar - Kramer VP-4x8AK User Manual

9

Controlling via the Embedded Web Pages

You can remotely operate the VP-4x8AK using a Web browser via the
Ethernet connection (see
supported Web browser; Microsoft (V6.0 and higher), Chrome, or Firefox
(V3.0 and higher).
To check that Java is installed correctly and running, browse to:
http://www.java.com/en/download/help/testvm.xml
This page runs a test and displays a Java success (see
message.
If you do not see the success message, follow the instructions on the page to:
• Load and enable Java
• Enable Javascript in your browser
9.1

Connecting to the VP-4x8AK via your Browser

Make sure that your PC is connected via a network to the VP-4x8AK and do
the following:
1. Open your Internet browser.
2. Enter the unit's IP number
If you are using DHCP, you have to enter the name.

Figure 16: Entering the IP Number in the Address Bar

1 The default IP number is 192.168.1.39, and may be changed by the system integrator
26
Controlling via the Embedded Web Pages
Section 9.1). To be able to do so, you must use a

Figure 15: Java Test Page Success Message

1
or name in the Address bar of your browser.
Figure 15) or failure
KRAMER: SIMPLE CREATIVE TECHNOLOGY