Table of Contents
Advertisement
3. Installation Instructions
3.1 Hole Cut Out
The cutout size required is 305mm (12")
3.2 Connections
The CMS60 ICT – 30 / CMS60 ICT - 4 is provided with a plugable European "Phoenix" type connector,
which is located on the back of the speaker can, under the wiring cover as shown in Figure
3a below. This consists of a plug and socket. The plug can be removed from the socket
(Figure 3b) for wiring.
Figure 3a.
Figure 3b.
The plug is wired to the amplifier such that the connections are as follows:
+ - - +
Pin 1 is Positive
Pin 2 is Negative
For additional speakers, pin 3 and 4 are in parallel with pins 1 and 2, where:
Pin 3 is Negative
Pin 4 is Positive
Before connecting the speaker, ensure the wiring cover and cable clamp on the back of the
can are open as shown in Figure 3c. Connect the wired plug into the socket.
Figure 3c
Advertisement
Table of Contents
